Top 7 Effective Steps on How to Retile a Shower

Let’s agree, the bathroom is among the most used rooms in our house. Besides, bathroom tiles are vulnerable to mold and mildew which can result in staining, making the ceramic tiles shower floor look ugly and worn. Retiling your shower will not only allow you replace shabby looking or damaged tiles but also allows you to improve the design of the old tiles designs. Here is a guide on how you can retile your shower.

1. Remove the Old Tiles

Using grout removing tools or a putty knife, remove the grout between the tiles to separate them. It is advisable not to break the old tiles because they can still be reused for other purposes. Pry the tile off its base by inserting the grout removing tool all the way beneath the tile, deep enough to remove the tile. Contact Omaharolloff.com to handle the removal of these pesky tiles. You will be glad you hired a dumpster hauler when the time comes.Tap the handle of the grout removing tool with a hammer to exert more force on the tile. Removing the other tiles is easier when the first one has been removed.

2. Examining the walls and the floor of the shower

After removing all the tiles, plan your wall out. Lay out the subway tiles pattern before you start tiling. This ensures there are no awkward slivers or small pieces of tiles along the edges of the floor and the wall. Ensure the surface has a slight slope and is free from stubborn tiles adhesives for proper adhesion of the new tiles.

3. Examine the Existing Water Barrier

A water barrier is a layer of material used to prevent water from soaking into the base of the shower floor. Ensure they are in good conditions after removing all tile adhesives. In case the water barriers are damaged, repair or replace them.

4. Apply an Even-Coat of Thinset mortar

Read the manufacturer’s instructions on mixing thinset mortar according to accordingly. Apply a thin coat of thinset on the area you would like to install the tiles. This is done where you can install the tiles within 15 minutes. It is not advisable to apply the mixture to the entire area at once.

5. Installing the Tiles

Comb the old thinset mortar you applied using an old comb, to ensures the tiles adhere better. Place the first row and tap gently on top of the ceramic tile sing a hammer and repeat this to all the tiles on the first row. Put a flat board on the tiles pressing gently, to ensure the tiles are evenly placed.

6.Use the Tile Spacers

Use a tile spacer mostly from your local home improvement depot, to make sure that the tiles are evenly placed. Check for any unexpected spacing and make necessary changes.

7.Apply the Grout

Ensure the thinnest mortar is fully dry before applying the grout. Read manufacturer’s instructions and mix the grout accordingly. Apply the grout in between the spaces of the tiles, removing excess grout with a wet sponge. Rinse the sponge and repeat the same until the floor is clean.

In Conclusion

Retiling your shower helps you provide a new color palette and also eases maintenance. Unlike painting, tiling might not be as easy as it looks. However, using these steps repetitively will perfect your skills.

Leave a Reply

Your email address will not be published. Required fields are marked *